• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 Focus RS Forum and Focus RS community dedicated to Focus RS owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the Focus RS Forum today!

Velossa Tech Diffuser Fins - New revision - bigger and badder!

Trader history for VelossaTech (0)

Messages
108
Likes
26
Location
Westland
#46
I have a renewing interest in these as I really like the new design revisions. I am looking for some input from those who have these installed on a catless car. Being catless, soot buildup on my bumper is inevitable (white platinum). Cleaning it off is no problem as long as I keep up with it. However, I think these fins are close enough to the exhaust to get "stained" by the exhaust flow, especially since I am interested in the off white ones to match my white platinum. Anyone with input or thoughts on this?

Edit: I can't spell
 
OP
VelossaTech

VelossaTech

Vendor
Premier Vendor
Messages
412
Likes
218
Location
fort lauderdale
Thread Starter #47
I have a renewing interest in these as I really like the new design revisions. I am looking for some input from those who have these installed on a catless car. Being catless, soot buildup on my bumper is inevitable (white platinum). Cleaning it off is no problem as long as I keep up with it. However, I think these fins are close enough to the exhaust to get "stained" by the exhaust flow, especially since I am interested in the off white ones to match my white platinum. Anyone with input or thoughts on this?

Edit: I can't spell
I can look into this for you.. Quite a few people run white fins. Luckily they wipe clean pretty easily.
 
Messages
108
Likes
26
Location
Westland
#48
I can look into this for you.. Quite a few people run white fins. Luckily they wipe clean pretty easily.
I was going to ask about the surface finish quality of these. I know some 3d prints come out very rough and it would be difficult to scrub exhaust soot off. But from what I have seen, these seem to be pretty smooth in finish.
 
OP
VelossaTech

VelossaTech

Vendor
Premier Vendor
Messages
412
Likes
218
Location
fort lauderdale
Thread Starter #49
I was going to ask about the surface finish quality of these. I know some 3d prints come out very rough and it would be difficult to scrub exhaust soot off. But from what I have seen, these seem to be pretty smooth in finish.
The parts are finished with a smoothing process. Here is an example.

 

Similar threads



Top