I purchased a 2017 RS yesterday and am super excited. I had a 2016 ST and enjoyed that car a lot. I put on a lot of miles between MN and IL so really like the AWD idea. I've alway been a big car guy so the performance will be fun.
I have two questions I am hoping to get some feedback on:
1. The car is certified used with low miles but the first owner put a muffler delete kit on it. It's obnoxious so I need to fix this. I am looking for advice on what muffler to get. I see quite a few people on forums that have mods listed without exhaust being one of them. Does this mean the stock system is good and I should just put the stock one back on? All I have found so far is CAT back systems and would rather not put all that on.
2. I am 6'2" tall. The primary concern i have had all along with the RS is the seat. I don't fit between the lower wings of the seat well and it is very uncomfortable. Has anyone had this issue and figured out some "minor" mods i could do or have an interior shop do? I can feel that there are hard supports in these sides of the seat, are they metal? If so i think they could just be bent outward a 1/2" on each side and that would make a huge differance? Idea's please...
I have two questions I am hoping to get some feedback on:
1. The car is certified used with low miles but the first owner put a muffler delete kit on it. It's obnoxious so I need to fix this. I am looking for advice on what muffler to get. I see quite a few people on forums that have mods listed without exhaust being one of them. Does this mean the stock system is good and I should just put the stock one back on? All I have found so far is CAT back systems and would rather not put all that on.
2. I am 6'2" tall. The primary concern i have had all along with the RS is the seat. I don't fit between the lower wings of the seat well and it is very uncomfortable. Has anyone had this issue and figured out some "minor" mods i could do or have an interior shop do? I can feel that there are hard supports in these sides of the seat, are they metal? If so i think they could just be bent outward a 1/2" on each side and that would make a huge differance? Idea's please...